English   español  
Please use this identifier to cite or link to this item: http://hdl.handle.net/10261/7148
logo share SHARE   Add this article to your Mendeley library MendeleyBASE
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL | DATACITE
Exportar a otros formatos:

DC FieldValueLanguage
dc.contributor.authorCuesta, María-
dc.contributor.authorCobo, Pedro-
dc.identifier.citation137th Meeting of the Acoustical Society of America. Structural Acoustics and Vibration ; 9en_US
dc.description4 pp.-- Comunicación presentada en: Joint Meeting "Berlin 99": 137th regular meeting of the Acoustical Society of America ; 2nd convention of the EAA: Forum Acusticum - integrating the 25th German Acoustics DAGA Conference. Berlin, March 14-19, 1999.en_US
dc.description.abstractAny practical noise control device requires a combination of passive and active methods. Passive control rises absorption properties of materials to reduce high frequency noise but it becomes expensive in terms of weight and bulk at low frequencies, where attenuation must be achieved with active control. Active control is based on the principle of destructive interference between the primary and the secondary sources. The aim of this work was to design and implement a hybrid passive/active system to control the exhaust noise radiated by a small generator. The fundamental frequency of the radiated periodic noise depends on the electrical load plugged in to the generator. Passive control is afforded by a rectangular enclosure with dimensions (1000 x 710 x 530 mm3). The wall panels of the enclosure are made of steel, 1.5 mm thick, lined with a 30 mm layer of absorbing material. The Measured Insertion Loss is higher than 20 dB above 500Hz. Special attention is paid to technical aspects such as air refreshing and temperature inside the enclosure. Low frequency noise escapes the enclosure via air intake and exhaust openings. Active control, implemented in a feedforward commercial system, is used to reduce low frequency exhaust noise below 500 Hz. The reference signal is supplied by an accelerometer located on the air filter case of the generator. A high temperature loudspeakser is used as control source. Active Attenuation is achieved in the band (50, 500) Hz, with the fundamental frequency reduced as much as 35 dB.en_US
dc.description.sponsorshipThis work has been supported by the CICYT, Project AMB97-1175-CO3-01.en_US
dc.format.extent808896 bytes-
dc.publisherDeutsche Gesellschaft für Akustiken_US
dc.titleA passive/active hybrid system for control of the noise radiated by a small enclosureen_US
dc.typecomunicación de congresoen_US
dc.description.peerreviewedPeer revieweden_US
Appears in Collections:(IA) Comunicaciones congresos
Files in This Item:
File Description SizeFormat 
3ASA___9.pdf789,94 kBAdobe PDFThumbnail
Show simple item record

WARNING: Items in Digital.CSIC are protected by copyright, with all rights reserved, unless otherwise indicated.