English   español  
Please use this identifier to cite or link to this item: http://hdl.handle.net/10261/62390
Share/Impact:
Statistics
logo share SHARE logo core CORE   Add this article to your Mendeley library MendeleyBASE

Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar a otros formatos:

Title

Endurance of TiAlSiN coatings: Effect of Si and bias on wear and adhesion

AuthorsPhilippon, D. ; Godinho, V. ; Nagy, P. M.; Delplancke-Ogletree, M. P.; Fernández-Camacho, A.
Issue Date2011
PublisherElsevier
CitationWear 270: 541- 549 (2011)
AbstractIn this work, the endurance of TiAlSiN nanocomposite thin films subjected to tribological solicitation is studied. These coating were deposited on M2 steel substrate by magnetron sputtering. Dry sliding experiments were conducted at ambient temperature against WC-Co ball. Coefficients of friction, wear rates and endurances were correlated with the composition, microstructure, mechanical properties, residual stress and adhesion of the coatings. The hardness and elastic modulus were found dependent not only on the composition but also on the residual stress induced by the deposition process. Friction coefficient was found to be independent on Si content while the wear rate is strongly reduced for higher Si contents. The formation of a nanocomposite microstructure, the amount of amorphous Si-based phase and both, wear resistance and adhesion are shown as the critical factors to determine the endurance of the coating. © 2011 Elsevier B.V.
URIhttp://hdl.handle.net/10261/62390
DOI10.1016/j.wear.2011.01.009
Identifiersdoi: 10.1016/j.wear.2011.01.009
issn: 0043-1648
Appears in Collections:(ICMS) Artículos
Files in This Item:
File Description SizeFormat 
43-2011.docx589,17 kBMicrosoft Word XMLView/Open
Show full item record
Review this work
 

Related articles:


WARNING: Items in Digital.CSIC are protected by copyright, with all rights reserved, unless otherwise indicated.