English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/44125
COMPARTIR / IMPACTO:
Estadísticas
logo share SHARE logo core CORE   Add this article to your Mendeley library MendeleyBASE

Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar a otros formatos:
Título

Trace analysis of antidepressants in environmental waters by molecularly imprinted polymer-based solid-phase extraction followed by ultra-performance liquid chromatography coupled to triple quadrupole mass spectrometry

AutorDemeestere, K.; Petrovic, Mira; Gros, Meritxell; Dewulf, J.; Van Langenhove, H.; Barceló, Damià
Palabras claveMolecularly imprinted polymers (MIP)
Selective serotonin reuptake inhibitors (SSRIs)
Benzodiazepines
Extraction
Environmental water analysis
Fecha de publicación2010
EditorSpringer
CitaciónAnalytical and Bioanalytical Chemistry
ResumenThis paper presents the development, optimization, and validation of an innovative method to analyze trace concentrations of seven selected psychoactive pharmaceuticals in environmental waters. Hereby, the solidphase extraction (SPE) potential of molecularly imprinted polymers (MIPs) in terms of extraction recovery, breakthrough, precision, and selectivity is studied for the first time. Instrumental analysis by ultra-performance liquid chromatography coupled to triple quadrupole mass spectrometry allowed a rapid (run time=7.5 min) and sensitive (instrumental
detection limit ≤7 pg injected) quantification of the target analytes. A systematic optimization study revealed that, among the seven compounds of interest, mainly the selective serotonin reuptake inhibitors paroxetine, fluoxetine, and citalopram are selectively retained on the MIPs. Experiments performed in spiked river water, sewage treatment plant (STP) effluent and influent showed for these compounds extraction recoveries higher than 70%, breakthrough volumes up to 200 mL, method detection limits (MDL) as low as 0.5 ng/L, and good precision (exemplified by relative standard deviations better than 15%, n≥3). Compared to the widely used hydrophilic–lipophilic balanced (HLB) polymers, the newly developed MIPs indicated to be more resistant toward matrix effects induced ion signal suppression particularly when dealing with relative dirty samples like STP influents. As a result of the better selectivity, the MDL obtained with the MIP-based SPE method was up to a factor of 7 lower compared to those obtained with a recently reported multiresidue HLB method. However, optimizing a HLB method in terms of selectivity, e.g., by introducing a stronger washing protocol, can significantly reduce its MDL up to values approximating those obtained with MIPs.
Versión del editorhttp:dx.doi.org/10.1007/s00216-009-3270-2
URIhttp://hdl.handle.net/10261/44125
DOI10.1007/s00216-009-3270-2
ISSN1618-2642
E-ISSN1618-2650
Aparece en las colecciones: (IDAEA) Artículos
Ficheros en este ítem:
No hay ficheros asociados a este ítem.
Mostrar el registro completo
 

Artículos relacionados:


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.