English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/22274
Compartir / Impacto:
Estadísticas
Add this article to your Mendeley library MendeleyBASE
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Título

Choosing the best geometries for the linear characterization of lossy piezoceramics: Study of the thickness-poled shear plate

AutorPardo, Lorena ; Montero de Espinosa Freijo, Francisco; García, Álvaro ; Brebøl, Klaus
Fecha de publicaciónmay-2008
EditorAmerican Institute of Physics
CitaciónApplied Physics Letters 92(17): 172907 (2008)
ResumenResonance modes of a thickness-poled piezoceramic shear plate are studied. When determining material properties from impedance measurements, it is required to obtain an uncoupled shear resonance. The shear resonance, which is electrically excited, results to a series of plate resonances, which is mechanically excited by this, when frequencies match. Thus, the condition of a high aspect ratio of the plate is not valid to eliminate coupling. Instead, the thickness (t) and lateral dimensions (L,w) of the plate must be tailored for each material. This approach was tested for a commercial piezoceramic and plates amenable for characterization obtained for aspect ratios below L:t = 15:1 (L = w).
Descripción3 pages, 2 figures
Versión del editorhttp://dx.doi.org/10.1063/1.2911731
URIhttp://hdl.handle.net/10261/22274
DOI10.1063/1.2911731
ISSN0003-6951
Aparece en las colecciones: (ICMM) Artículos
(IA) Artículos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
httpGetPDFServlet10.1063_1.pdf552,81 kBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 

Artículos relacionados:


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.