English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/2165
Compartir / Impacto:
Estadísticas
Add this article to your Mendeley library MendeleyBASE
Ver citas en Google académico
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar otros formatos: Exportar EndNote (RIS)Exportar EndNote (RIS)Exportar EndNote (RIS)
Título : Effect of mechanical alloying and Ti addition on solution and ageing treatment of an AA7050 aluminium alloy
Autor : Cardoso, Kátia Regina; Travessa, Dilermando Nagle; García Escorial, Asunción; Lieblich, Marcela
Palabras clave : Mechanical alloying
Aluminium alloy
Heat treatment
Fecha de publicación : jun-2007
Editor: Universidade Federal de São Carlos
Citación : Mat. Res. 2007, vol. 10, no. 2, pp. 199-203.
Resumen: In this work, solution heat treatments at different temperatures were performed in a commercial based AA7050 aluminium alloy, with and without titanium addition, produced by mechanical alloying and hot extrusion with the aim to investigate the effect of titanium addition and mechanical alloying in the precipitates stability. The same heat treatment conditions were used in a reference sample obtained from a commercial AA7050 alloy. Solution heat treated samples were characterised by differential scanning calorimetry (DSC), optical microscopy and hardness test. Once the better temperature for the solution treatment of modified alloys was defined, the ageing curve at 120°C was obtained to verify the effect of milling and Ti addition in the precipitation and in the maximum values of hardness obtained for the alloys.
URI : http://hdl.handle.net/10261/2165
ISSN: 1516-1439 (versión impresa)
Aparece en las colecciones: (CENIM) Artículos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
Cardoso et al.pdf1,62 MBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.