English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/159436
COMPARTIR / IMPACTO:
Estadísticas
logo share SHARE logo core CORE   Add this article to your Mendeley library MendeleyBASE

Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar a otros formatos:
Título

Chemical Looping Combustion of liquid fossil fuels in a 1 kWth unit using a Fe-based oxygen carrier

AutorSerrano, A.; García-Labiano, Francisco ; Diego Poza, Luis F. de ; Gayán Sanz, Pilar ; Abad Secades, Alberto ; Adánez Elorza, Juan
Palabras claveCO2 capture
liquid fossil fuels,
Chemical Looping Combustion;
Oxygen carrier
Fecha de publicación1-jun-2017
EditorElsevier
CitaciónFuel Processing Technology 160: 47-54 (2017)
ResumenThe integrated use of low-value hydrocarbons from the refining of crude oil under Chemical Looping Combustion (CLC) conditions can satisfy the demands of heat and steam of the refining process itself while at the same time reducing CO2 emissions up to 50% in oil refineries. This work evaluated the use of three different fossil liquid fuels, i.e., diesel, mineral lubricant oil and synthetic lubricant oil in a 1 kWth CLC continuous unit working with a Fe-based oxygen carrier prepared by impregnation method. The effect of key parameters of the CLC process behavior was studied with the same batch of oxygen carrier particles for a total of 150 operation hours. With regard to the results obtained, every fuel tested was able to achieve 90% combustion efficiency being synthetic lubricant oil the most reactive fuel studied. Hydrocarbon reactivity seems to depend on the nature of the chemical bonds, being higher for alkenes (synthetic lubricant oil) than for alkanes (diesel and mineral lubricant oil). CH4 was revealed as a relatively stable intermediate combustion product for these liquid fuels. Therefore, oxygen carrier’s reactivity towards this gas becomes crucial for the overall conversion. The characterization carried out to the oxygen carrier after operation revealed no evidence of changes derived from the sulphur or impurities present in the fuel. Therefore, the Fe-based material herein used seems to be suitable for conversion of fossil liquid fuels.
Versión del editorhttps://doi.org/10.1016/j.fuproc.2017.02.015
URIhttp://hdl.handle.net/10261/159436
DOI10.1016/j.fuproc.2017.02.015 Get
ISSN0378-3820
Aparece en las colecciones: (ICB) Artículos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
6_postprint FPT 160 (2017) 47_54.pdf Embargado hasta 1 de junio de 2019990,19 kBAdobe PDFVista previa
Visualizar/Abrir     Petición de una copia
Mostrar el registro completo
 


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.