English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/156432
COMPARTIR / IMPACTO:
Estadísticas
logo share SHARE   Add this article to your Mendeley library MendeleyBASE

Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar a otros formatos:
Título

Hydromechanical Aspects of CO2 Breakthrough into Clay-rich Caprock

AutorMakhnenko, Roman Y.; Vilarrasa, Víctor; Mylnikov, Danila; Laloui, Lyesse
Palabras claveBreakthrough pressure
Caprock
Liquid and supercritical CO2
Permeability
Shale
Fecha de publicación2017
EditorElsevier
CitaciónEnergy Procedia 114: 3219-3228 (2017)
ResumenCaprock formations are intended to prevent upwards carbon dioxide (CO2) migration to the surface during CO2 geological storage. Caprock interaction with CO2, as well as its potential consequences, requires to be predicted, and thus, need to be studied experimentally. Laboratory investigations of caprock behavior are complex due to its low permeability, and the scarcity of experimental studies involving high-pressure CO2 injection into caprock representatives puts this difficulty into manifest. In this study, we perform laboratory experiments in an oedometric cell on intact and remolded Opalinus clay (Jurassic shale), evaluating the breakthrough pressure and permeability for liquid and supercritical CO2. Intact and remolded shale specimens present intrinsic permeabilities of 10-21 m2 to 10-20 m2, respectively. Applied axial stress ranges from 27 MPa to 42 MPa and the pressure and temperature conditions are representative of a caprock at a depth of 800 m. We found that the microstructure of the caprock has a great effect on the material properties. The intrinsic permeability of a more tight material (intact Opalinus clay) is around two times lower than that of remolded shale, which has a more open microstructure. Additionally, the intact rock becomes 30 times less permeable to CO2 than the remolded shale, which implies that the CO2 relative permeability is 15 times smaller for intact rock than for remolded shale. On the other hand, CO2 breakthrough pressure for the tighter material is almost three times lower than for the more permeable remolded shale. Breakthrough pressure of the remolded shale ranges from 3.9 MPa to 5.0 MPa for liquid CO2 and from 2.8 MPa to 4.6 MPa for supercritical CO2. For the intact shale, breakthrough pressure is 0.9 MPa for liquid CO2 and 1.6 MPa for supercritical CO2. Thus, the breakthrough pressure cannot be correlated with the intrinsic permeability of the caprock. © 2017 The Authors.
Versión del editor10.1016/j.egypro.2017.03.1453
URIhttp://hdl.handle.net/10261/156432
DOI10.1016/j.egypro.2017.03.1453
Aparece en las colecciones: (IDAEA) Comunicaciones congresos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
Hydromechanical aspects of CO2 breakthrough into clay-rich.pdf1,01 MBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.