English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/133239
Compartir / Impacto:
Estadísticas
Add this article to your Mendeley library MendeleyBASE
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Título

Optimization of hydrogen production with CO2 capture by autothermal chemical-looping reforming using different bioethanol purities

AutorGarcía-Díez, E.; García-Labiano, Francisco Javier; Diego Poza, Luis F. de; Abad Secades, Alberto; Gayán Sanz, Pilar; Adánez Elorza, Juan; Ruíz, J.A.C.
Palabras claveHydrogen production
CO2 capture
Chemical-looping reforming
Oxygen-carrier
Bioethanol
Heat balance
Fecha de publicaciónfeb-2016
EditorElsevier
CitaciónApplied Energy 169: 491-498 (2016)
ResumenAutothermal Chemical-Looping Reforming (a-CLR) is a process which allows hydrogen production avoiding the environmental penalty of CO2 emission typically produced in other processes. The major advantage of this technology is that the heat needed for syngas production is generated by the process itself. This heat necessary for the endothermic reactions is supplied by a Ni-based oxygen-carrier (OC) circulating between two reactors: the air reactor (AR), where the OC is oxidized by air, and the fuel reactor (FR), where the fuel is converted to syngas. Other important advantage is that this process also allows the production of pure N2 in the AR outlet stream. A renewable fuel such as bioethanol was chosen in this work due to their increasing worldwide production and the current excess of this fuel presented by different countries. In this work, mass and heat balances were done to determine the auto-thermal conditions that maximize H2 production, assuming that the product gas was in thermodynamic equilibrium. Three different types of bioethanol has been considered according to their ethanol purity; Dehydrated ethanol (≈100 vol.%), hydrated ethanol (≈96 vol.%), and diluted ethanol (≈52 vol.%). It has been observed that the higher H2 production (4.62 mol of H2 per mol of EtOH) has been obtained with the use of diluted ethanol and the surplus energy needed could be compensated by the energy save achieved during the purification of ethanol in the production process.
Versión del editorhttp://dx.doi.org/10.1016/j.apenergy.2016.02.061
URIhttp://hdl.handle.net/10261/133239
DOI10.1016/j.apenergy.2016.02.061
ISSN0306-2619
Aparece en las colecciones: (ICB) Artículos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
Postprint_Applied Energy 169 (2016) 491-498-2.pdf409,83 kBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 

Artículos relacionados:


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.