English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/121598
Compartir / Impacto:
Estadísticas
Add this article to your Mendeley library MendeleyBASE
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Título

Sliding wear resistance of biomorphic SiC ceramics

AutorVera, M.C. ; Ramírez-Rico, J.; Martínez-Fernández, Julián; Singh, M.
Palabras claveWear
Silicon carbide
Composites
Silicon
Porous materials
Fecha de publicación2015
EditorElsevier
CitaciónInternational Journal of Refractory and Hard Materials, 49:327-333 (2015)
ResumenBiomorphic SiC ceramics were fabricated from four different wood precursors and their Knoop hardness and sliding wear resistance when sliding against a Si3N4 ball in air were studied. Tribological experiments were performed using a pin on disk apparatus, under normal loads of 2 and 5 N, at a sliding speed of 100 mm/s. The effects of specimen porosity and microstructure on measured wear were evaluated. A commercial sintered silicon carbide ceramic was also tested for comparison. Small differences in friction coefficient comparable to monolithic SiC ceramics were obtained. Several concurrent wear mechanisms are taking place: microfracture, plastic deformation in the Si phase and oxidation of the Si and/or SiC phase. The presence of an oxide tribolayer was assessed using fluorescence microscopy. Wear rates were found to scale with SiC content and depend on residual porosity in the composite.
Versión del editorhttp://dx.doi.org/10.1016/j.ijrmhm.2014.07.004
URIhttp://hdl.handle.net/10261/121598
DOI10.1016/j.ijrmhm.2014.07.004
Aparece en las colecciones: (ICMS) Artículos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
Wear_bioSiC_final.pdf2,58 MBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 

Artículos relacionados:


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.