English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/112349
Compartir / Impacto:
Estadísticas
Add this article to your Mendeley library MendeleyBASE
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Título

Evaluation of elastic modulus and hardness of Fe-Al base intermetallics by nano-indentation techniques

AutorFrutos, E.; Morris, David G.; Muñoz-Morris, Mª Antonia
Palabras claveIron aluminides (based on Fe3Al and FeAl)
Elastic properties
Mechanical properties at ambient temperature
Fecha de publicación2013
EditorElsevier
CitaciónIntermetallics 38: 1-3 (2013)
ResumenNanoindentation has been used to study Young's modulus and hardness of Fe-Al alloys with Al contents from 22 to 47 at%, and the influence of Cr additions to near Fe3Al alloys. Materials are examined in the quenched state and the well-annealed state with, respectively, relatively poor order with retained thermal vacancies, and good order with few vacancies. Significant changes occur in both modulus and hardness, affected by Al content, Cr addition and heat treatment. These changes are discussed in terms of state of order, possible role of magnetisation, and vacancies. © 2013 Elsevier Masson SAS. All rights reserved.
URIhttp://hdl.handle.net/10261/112349
DOI10.1016/j.intermet.2013.02.012
Identificadoresdoi: 10.1016/j.intermet.2013.02.012
issn: 0966-9795
Aparece en las colecciones: (CENIM) Artículos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
accesoRestringido.pdf15,38 kBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 

Artículos relacionados:


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.