English   español  
Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/107905
Compartir / Impacto:
Estadísticas
Add this article to your Mendeley library MendeleyBASE
Ver citas en Google académico
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar otros formatos: Exportar EndNote (RIS)Exportar EndNote (RIS)Exportar EndNote (RIS)
Título

Microtubular SOFC based on an extruded support

Autor Monzón, Hernán; Laguna-Bercero, M. A.; Larrea, A. ; Arias, B. I.; Várez, A.; Levenfeld, B.
Palabras clave Microtubular
Powder extrusion moulding
SOFC
Fecha de publicación 2013
Citación HYCELTEC 2013
ResumenIn this work the processing route for an anode supported microtubular solid oxide fuel cell is adjusted. The fuel cell composition and microstructure design is based on previous work. In this work we have developed microtubular cells based on an extruded support. Firstly, Ni-YSZ anode was manufactured by Powder Extrusion Moulding (PEM). Feedstock composition and extruding parameters were adjusted to obtain tubular green bodies. An YSZ layer was then deposited as the electrolyte and the sintering parameters were optimized to obtain a dense layer. An active area of ~1 cm2 LSMYSZ was deposited as the cathode and its electrochemical performance was measured using pure hydrogen as fuel, yielding a power output at 0.5V of 0.7Wcm-2 at 8500C.
Descripción Trabajo presentado al "IV Iberian Symposium on Hydrogen, Fuel Cells and Advanced Batteries" celebrado en Estoril (Portugal) del 26 al 28 de junio de 2013.
Versión del editorhttp://www.hyceltec2013.com/
URI http://hdl.handle.net/10261/107905
Aparece en las colecciones: (ICMA) Comunicaciones congresos
Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
Microtubular SOFC.pdf604,59 kBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo
 


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.