English   español  
Please use this identifier to cite or link to this item: http://hdl.handle.net/10261/76732
Share/Impact:
Statistics
logo share SHARE logo core CORE   Add this article to your Mendeley library MendeleyBASE

Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL
Exportar a otros formatos:
Title

Characterization of the elastic-plastic behavior of intermetallic coatings growth on medical stainless steel by instrumented ultramicroindentation

AuthorsFrutos, E.; Cuevas, A.; González-Carrasco, José Luis; Martín, F.
Issue Date2012
PublisherElsevier
CitationJournal of the Mechanical Behavior of Biomedical Materials 16: 1-8 (2012)
AbstractThe purpose of this work is to study the elastoplastic properties of novel intermetallic coatings grown by hot dipping on medical steel 316 LVM and their correlation with the scratch resistance by means of instrumented ultramicroindentation techniques. Elasto-plastic properties are defined by the plasticity index (PI), which correlates the hardness and the Young's modulus, and the yield strength that delimits the elastic-plastic transition. To avoid overestimations of the PI due to the so-called indentation size effect, macroscopic hardness values were determined. The PI of the coating increases from 0.6 to 0.8 with increasing immersion time. These values are always lower than those of the bare substrate (0.9) but higher than those found for ceramics (~0.5). The increase of the PI is accompanied by a decrease in the yield strength from 0.73 to 0.34 GPa, which highlights the relevance of the compressive residual stresses and their relaxation with increasing immersion time. The higher plasticity is shown by higher apparent friction coefficients (0.159), which are Mechanical propertiesalways lower than those of the bare steel (0.264). Therefore, these intermetallic coatings could be considered >hard but tough>coatings, suitable for enhancing the wear resistance of the medical steel, especially when using short periods of immersion. The study provides evidence that the load-depth curve of indentation contains abundant information and that its analysis can be used to determine various mechanical properties of coatings that could be important for load bearing components. © 2012 Elsevier Ltd. All rights reserved.
URIhttp://hdl.handle.net/10261/76732
DOI10.1016/j.jmbbm.2012.08.008
Identifiersdoi: 10.1016/j.jmbbm.2012.08.008
issn: 1751-6161
Appears in Collections:(CENIM) Artículos
Files in This Item:
File Description SizeFormat 
accesoRestringido.pdf15,38 kBAdobe PDFThumbnail
View/Open
Show full item record
Review this work
 

Related articles:


WARNING: Items in Digital.CSIC are protected by copyright, with all rights reserved, unless otherwise indicated.