Please use this identifier to cite or link to this item: http://hdl.handle.net/10261/56385
Share/Impact:
Título : Pinning Forces Exerted by TiN Particles in Austenite of Structural Steels and Comparison with Driving Forces for Grain Growth and for Static Recrystallisation
Autor : Chaves, J. I., Medina, Sebastián F., Gómez, Manuel, Rancel, Lucía, Valles, Pilar
Palabras clave : Driving force
Hot rolling simulation,
Pinning force
TiN Precipitates
Fecha de publicación : 2007
Editor: Trans Tech Publications
Resumen: In this work the pinning forces exerted by TiN particles in the austenitic phase in two Ti microalloyed steels have been determined and compared with the driving forces for austenite grain growth and for static recrystallisation between hot rolling passes, respectively. TiN precipitate sizes were measured by transmission electron microscopy (TEM) and the precipitated volumes were calculated. These results were then used to calculate pinning forces. The driving forces for recrystallisation were found to be approximately two orders of magnitude higher than the pinning forces, which explains why the austenite in these steels barely experiences hardening during rolling and why the accumulated stress prior to the austenite→ferrite transformation is insufficient (low dislocation density) to refine the ferritic grain.
Versión del editor: http://dx.doi.org/10.4028/www.scientific.net/MSF.550.405
URI : http://hdl.handle.net/10261/56385
ISSN: 0255-5476
DOI: 10.4028/www.scientific.net/MSF.550.405
Citación : Materials Science Forum 550 : 405-410 (2007)
Appears in Collections:(CENIM) Artículos

Files in This Item:
There are no files associated with this item.
Show full item record
 
CSIC SFX LinksSFX Query

Items in Digital.CSIC are protected by copyright, with all rights reserved, unless otherwise indicated.