Por favor, use este identificador para citar o enlazar a este item: http://hdl.handle.net/10261/207705
COMPARTIR / EXPORTAR:
logo share SHARE BASE
Visualizar otros formatos: MARC | Dublin Core | RDF | ORE | MODS | METS | DIDL | DATACITE

Invitar a revisión por pares abierta
Título

A Modified Iterative Automatic Method for Characterization at Shear Resonance: Case Study of Ba0.85Ca0.15Ti0.90Zr0.10O3 Eco-Piezoceramics

AutorPardo, Lorena CSIC ORCID; Reyes-Montero, Armando; García, Álvaro CSIC; Jacas-Rodríguez, Alfredo; Ochoa, Pilar CSIC; González, Amador M.; Jiménez-Martínez, Francisco Javier; Vázquez-Rodríguez, Manuel; Villafuerte-Castrejón, María E.
Palabras clavePiezoelectrics
Ferroelectrics
Dielectrics
Barium titanate
Zirconates
Ceramics
Characterization
Impedance
Losses
Shear
Fecha de publicación3-abr-2020
EditorMultidisciplinary Digital Publishing Institute
CitaciónMaterials 13 (7): 1666 (2020)
ResumenCoupling between electrically excited electromechanical resonances of piezoelectric ceramics is undesirable for the purpose of their characterization, since the material models correspond to monomodal resonances. However, coupling takes place quite often and it is unavoidable at the shear resonance of standard in-plane poled and thickness-excited rectangular plates. The piezoelectric coefficient e15, the elastic compliance s55E and the dielectric permittivity component ε11S for a piezoelectric ceramic can be determined, including all losses, using the automatic iterative method of analysis of the complex impedance curves for the shear mode of an appropriated resonator. This is the non-standard, thickness-poled and longitudinally excited, shear plate. In this paper, the automatic iterative method is modified. The purpose is to be able to deal with the analysis of the impedance curves of the non-standard plate as the periodic phenomena of coupling and decoupling of the main shear resonance and other resonances takes place. This happens when the thickness of the plate is reduced, and its aspect ratio (width of the excitation (w)/thickness for poling (t)) is increased. In this process, the frequency of the shear resonance also increases and meets those of other plate modes periodically. We aim to obtain the best approach for the shear properties of near coupling and to reveal both their validity and the limitations of the thus-obtained information. Finally, we use a plate of a Ba0.85Ca0.15Ti0.90Zr0.10O3 eco-piezoceramic as a case study.
Versión del editorhttp://dx.doi.org/10.3390/ma13071666
URIhttp://hdl.handle.net/10261/207705
DOI10.3390/ma13071666
Identificadoresdoi: 10.3390/ma13071666
Aparece en las colecciones: (ICMM) Artículos




Ficheros en este ítem:
Fichero Descripción Tamaño Formato
materials-13-01666-v3.pdf3,41 MBAdobe PDFVista previa
Visualizar/Abrir
Mostrar el registro completo

CORE Recommender

WEB OF SCIENCETM
Citations

3
checked on 23-nov-2021

Page view(s)

190
checked on 28-mar-2024

Download(s)

114
checked on 28-mar-2024

Google ScholarTM

Check

Altmetric

Altmetric


NOTA: Los ítems de Digital.CSIC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.